User Manual

User's Guide Fireface UCX © RME
65
27.6 Reverb and Echo
A click on FX in the View Options / Mixer Setup brings up the Output FX panel. Here all pa-
rameters for the effects Reverb and Echo are adjusted.
Reverb. Activated by the On button.
Type. Lists different reverb algorithms for selection. Available are:
¾ Rooms 1 - 4. Algorithm for room simulation with different tonal
colours. Room 1 and 2 sound dry and small, Room 3 and 4 brilliant
and a bit bigger.
¾ Envelope. Reverb effect in multitap technology, where the volume
course (envelope) is freely adjustable.
¾ Gated. Simpler version of the Envelope reverb for cut reverb
effects.
¾ Classic. Classic feedback-based reverb with comb filter, generating
both the typical sound and the very long reverb times.
General Settings
PreDelay. Delay of the reverb signal. Adjustable from the current buffer
size (some milliseconds) up to 999 ms.
Low Cut. High-pass filter before the reverb generation, removes low
frequency signals which should not cause a reverb sound. Adjustable
from 20 Hz up to 500 Hz.
Smooth. Softens the reverb effect, affects stereo width, density and
sound colour. Adjustable from 0 up to 100.
Width. Adjusts the stereo width of the reverb signal from 100 (stereo) to
0 (mono).
Volume. Adjusts the level of the reverb effects signal sent to the FX
return bus.
Special Settings for Room 1-4
High Cut. Low-pass filter after the reverb generation. A reduction of the treble often lets the
reverb sound more natural. Adjustable from 5 kHz up to 20 kHz.
Room Scale. Determines the size of the room, thus changing density and length of the reverb
effect. Adjustable from 0.5 up to 2.0.