User Manual

User's Guide Fireface 800 © RME
10
SyncCheck
SyncCheck indicates whether there is a valid signal (Lock, No Lock) for each input (Word
clock, ADAT1, ADAT2, SPDIF), or if there is a valid and synchronous signal (Sync). The Auto-
Sync Ref display shows the input and frequency of the current sync source.
Options
Check Input verifies the current digital input signal against the settings in the record program.
When de-activated a recording will always be allowed, even with non-valid input signals. Check
Input is valid for MME only.
SyncAlign guarantees synchronous channels when using MME multitrack software. This option
should only be switched off in case the used software does not work correctly with SyncAlign
activated.
TMS activates the transmission of Channel Status data and Track Marker information of the
SPDIF input.
With Interleaved activated, the WDM devices can also be used as 8-channel devices (see
chapter 9.6).
Clock Mode
The card can be configured to use its
internal clock source (Master), or the
clock source pre-defined via Pref. Sync
Ref (AutoSync).
Pref. Sync Ref.
Used to pre-select the desired clock
source. If the selected source isn't
available, the system will change to the
next available one. The current clock
source and sample rate is displayed in
the AutoSyncRef display.
The automatic clock selection checks
and changes between the clock sources
Word Clock, ADAT1, ADAT2, SPDIF,
LTC and Video (LTC/Video when using
the optional TCO module).
System Clock
Shows the current clock state of the
Fireface 800. The system is either Mas-
ter (using its own clock) or Slave (Auto-
Sync Ref).
Read Flash Memory
A click on this button causes all settings to change to the ones stored in the flash memory of
the Fireface.
Store in Flash Memory
A click on this button transmits all current settings into the flash memory of the Fireface.