User Manual

User's Guide Digiface AVB © RME

23. Declaration of Conformity

This device has been tested and found to comply with the limits of the European Council Direc-

tive on the approximation of the laws of the member states relating to electromagnetic compati-

bility according to RL2004/108/EG, and European Low Voltage Directive RL2006/95/EG.

FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device must ac-

cept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

Responsible Party in USA:

Synthax United States, 6600 NW 16th Street, Suite 10, Ft Lauderdale, FL 33313

T.:754.206.4220

Trade Name: RME, Model Number: Digiface AVB

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar-

antee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

RoHS

This product has been soldered lead-free and fulfils the requirements of the RoHS directive.

Note on Disposal

According to the guide line RL2002/96/EG (WEEE – Directive on Waste

Electrical and Electronic Equipment), valid for all european countries,

this product has to be recycled at the end of its lifetime.

In case a disposal of electronic waste is not possible, the recycling can

also be done by IMM electronics GmbH, the manufacturer of the

Digiface AVB.

For this the device has to be sent free to the door to:

IMM electronics GmbH

Leipziger Straße 32

D-09648 Mittweida

Germany

Shipments not prepaid will be rejected and returned on the original sender's costs.