User Manual

32
User's Guide Babyface Pro FS © RME
16. Configuring the Babyface Pro
16.1 Settings Dialog
Configuring the Babyface Pro is done via its own settings dialog. Start the program Fireface
USB Settings. The mixer of the Babyface Pro (TotalMix FX) can be configured by starting the
program Totalmix.
The Babyface Pro’s hardware offers a number of helpful, well thought-out practical functions
and options which affect how the card operates - it can be configured to suit many different
requirements.
The following is available in the
Settings dialog:
x Configuration of the digital I/O
x Current sample rate
x Synchronization behaviour
x State of input and output
Any changes performed in the
Settings dialog are applied
immediately - confirmation (e.g. by
exiting the dialog) is not required.
However, settings should not be
changed during playback or record
if it can be avoided, as this can
cause unwanted noises.
Use the drop down menu
Properties For to select the unit to
be configured.
On the right of it the current
firmware and driver version is
shown.
Options
DSP – EQ for Record
Switches the 3-band EQ and Low Cut of all input channels into the recording path. In case
Loopback has been activated the EQ and Low Cut of the Output channel is placed into the re-
cording path. See also chapter 23.6.
Optical Out
The optical TOSLINK output can operate as ADAT or SPDIF output. The Channel Status is
fixed to Consumer state.
Note
: The optical input detects the incoming format automatically.
Clock Mode
Sample Rate
Used to set the current sample rate. This is the same setting as in the Audio MIDI Setup, just
added here for your convenience.