User Manual

80
User's Guide Babyface Pro © RME
26.6 Noise Level in DS / QS Mode
The outstanding signal to noise ratio of the Babyface Pro's AD-converters can be verified even
without expensive test equipment, by using record level meters of various software. But when
activating the DS and QS mode, the displayed noise level will rise from -113 dB to -105 dB at 96
kHz, and –79 dB at 192 kHz. This is not a failure. The software measures the noise of the whole
frequency range, at 96 kHz from 0 Hz to 48 kHz (RMS unweighted), at 192 kHz from 0 Hz to 96
kHz.
When limiting the measurement range from 20 Hz to 20 kHz (so called audio bandpass) the
value would be -113 dB again. This can be verified with RME's DIGICheck. The function Bit
Statistic & Noise measures the noise floor by Limited Bandwidth, ignoring DC and ultrasound.
The reason for this behaviour is the noise shaping technology of the analog to digital convert-
ers. They move all noise and distortion to the inaudible higher frequency range, above 24 kHz.
That’s how they achieve their outstanding performance and sonic clarity. Therefore the noise is
slightly increased in the ultrasound area. High-frequency noise has high energy. Add the dou-
bled (quadrupled) bandwidth, and a wideband measurement will show a significant drop in
SNR, while the human ear will notice absolutely no change in the audible noise floor.
26.7 SteadyClock
The further improved SteadyClock III technology of the Babyface Pro guarantees an excellent
performance in all clock modes. Thanks to a highly efficient jitter suppression, the AD- and DA-
conversion always operates on highest sonic level, being completely independent from the
quality of the incoming clock signal.
SteadyClock has been originally de-
veloped to gain a stable and clean
clock from the heavily jittery MADI
data signal (the embedded MADI clock
suffers from about 80 ns jitter). Using
the Babyface Pro's input signals
SPDIF and ADAT, you'll most probably
never experience such high jitter
values. But SteadyClock is not only
ready for them, it would handle them
just on the fly.
Common interface jitter values in real
world applications are below 10 ns, a
very good value is less than 2 ns.
The screenshot shows an extremely jittery SPDIF signal of about 50 ns jitter (top graph, yellow).
SteadyClock turns this signal into a clock with less than 2 ns jitter (lower graph, blue). The sig-
nal processed by SteadyClock is of course not only used internally, but also used to clock the
digital output. Therefore the refreshed and jitter-cleaned signal can be used as reference clock
without hesitation.