User Manual

User's Guide Babyface Pro © RME

16. Configuring the Babyface Pro

16.1 Settings Dialog

Configuring the Babyface Pro is done via its own settings dialog. Start the program Fireface

USB Settings. The mixer of the Babyface Pro (TotalMix FX) can be configured by starting the

program Totalmix.

The Babyface Pro’s hardware offers a number of helpful, well thought-out practical functions

and options which affect how the card operates - it can be configured to suit many different

requirements.

The following is available in the Settings dialog:

• Operation of the DSP

• Configuration of the digital I/O

• Current sample rate

• Synchronization behaviour

• State of input and output

Any changes performed in the

Settings dialog are applied

immediately - confirmation (e.g. by

exiting the dialog) is not required.

However, settings should not be

changed during playback or record

if it can be avoided, as this can

cause unwanted noises.

Use the drop down menu

Properties For to select the unit to

be configured.

On the right of it the current

firmware and driver version is

shown.

Options

DSP – EQ for Record

Switches the 3-band EQ and Low Cut of all input channels into the recording path. In case

Loopback has been activated the EQ and Low Cut of the Output channel is placed into the re-

cording path. See also chapter 23.6.

Optical Out

The optical TOSLINK output can operate as ADAT or SPDIF output. The Channel Status is

fixed to Consumer state.

Note

: The optical input detects the incoming format automatically.