Manualshelf

User Manual

ManualsBrandsRME ManualsAudio Interfaces & SystemsHDSP 9652 Hammerfall - 26 Input / 26 Output 24-bit/96kHz PCI card with ADAT and S/PDIF I/O, MIDI I/O and ADAT Sync for Mac and Windows
21222324252627282930
30
User's Guide HDSP System HDSP 9652 © RME
18. Driver and Flash Update
18.1 Driver Installation
First fit the card (see 5. Hardware Installation), then switch on the computer and install the driv-
ers from the RME Driver CD. The driver file is located in the folder Hammerfall DSP. Installa-
tion works automatically by a double-click on the file hdsp.mpkg.
RME recommends to download the latest driver version from the RME website! If done, the
procedure is as follows:
Double-click onto hdsp_16c.gz to expand the archive file to hdsp_16c.tar and the folder
hdsp_16c, which includes the driver file hdsp.mpkg. Installation works automatically by a dou-
ble-click on this file.
During driver installation the programs Settings and Mixer (TotalMix) will also be installed. Both
programs start automatically as soon as a HDSP system is detected. They stay in the dock
when exited, and remove themselves automatically from the dock when the HDSP system is
removed.
Reboot the computer when installation is done.
18.2 Driver Update
In case of a driver update it's not necessary to remove the old driver first, it will be overwritten
during the installation.
Exception: driver updates from version <1.6. Remove the former Settings dialog and To-
talMix from the Login Items, and delete both files from your hard drive!
This driver version did not have the features AutoLoad, Dock Lock and AutoRemove. Therefore
one has to make sure that both programs have been removed from the system, to prevent the
old Settings dialog and TotalMix from being loaded.
18.3 Flash Update
The Flash Update Tool updates HDSP 9652 to the latest version. It requires an already installed
driver.
Start the program HDSP Flash. The Flash Update Tool displays the current revision of the
HDSP 9652, and whether it needs an update or not. If so, then simply press the 'Update' button.
A progress bar will indicate when the flash process is finished. The bar moves slowly first (pro-
gram), then faster (verify).
If more than one interface card is installed, all cards can be flashed by changing to the next tab
and repeating the process.
After the update the PCI card needs to be reset. This is done by powering down and shutting off
the PC. A warm boot is not enough!
When the update fails (status: failure), the card's second BIOS will be used from the next cold
boot on (Secure BIOS Technology). Therefore the card stays fully functional. The flash process
should then be tried again on a different computer.