User Manual

User's Guide Fireface UFX+ © RME
35
Sample Rate
Used to set the current sample rate. This is the same setting as in the Audio MIDI Setup, just
added here for your convenience.
Clock Source
The unit can be configured to use its own clock (Internal = Master), or one of the input signals
(Word, AES, ADAT1, ADAT2, MADI optical, MADI coaxial). If the selected source isn't available
(Input Status No Lock), the unit will change to the next available one (AutoSync). If none is
available then the internal clock is used. The current clock source is displayed below.
MADI Input Status
Indicates for each input MADI input
whether there is a valid signal
(Lock, No Lock), or if there is a
valid and synchronous signal
(Sync). The third column shows
the sample frequency measured
by the hardware. The fourth and
fifth column show the input’s
channel format (48k/96k Frame,
64 or 56 channels).
Bus
USB3 – Iso Transfer Format
The UFX+ uses a special
transmission mode with error
correction in record mode. In case
the default mode does not work
Isochronous Streaming can be
tried. This is the standard’s native
mode for audio transmission and
should work with any USB 3
controller. See chapter 39.3.
CRC Errors
Shows transmission errors on the
USB bus. See chapter 39.3.