User Manual

User's Guide Fireface UFX II © RME

The playback from a storage device does not change the current sample rate. To match pitch

and speed, the sample rate has to be set manually to the correct value. Playback can be as-

signed to multiple outputs.

The UFX can play back externally recorded WAV files, as long as these have 16 or 24 bit reso-

lution.

The recording signal is taken before EQ and Dynamics, on both inputs and outputs. To record

with EQ/Dyn, activate REC on an output and route a signal processed by the input EQ/Dyn to

that output. The insert point of playback is at the same place.

The block diagram shows the signal flow for various situations, depending on the state of Loop-

back, EQ for Record and Play active. In the diagram Loopback and EQ are switched to off, but

a playback is active in the input.

Some extra notes that are worth to be pointed out again:

• The signal recorded by audio software is usually that from the input. But when the option

DSP – EQ for Record has been activated in the Settings dialog the software receives the

Play input signal – as soon as a playback is started from the USB device.

• On an output Echo/Reverb gets recorded. To add Echo/Reverb to a playback the playback

must be assigned to an input.

• A playback via USB can not be processed and immediately recorded again via DURec. Whi-

le the block diagram seems to present such functionality please remember that DURec can

do only one thing at a time – record or playback.