User Manual

User's Guide Fireface UFX II © RME
65
!
Hidden channels in Mixer/Matrix are still fully functional. An existing routing/mixing/FX process-
ing stays active. But as the channel is no longer visible it can not be edited anymore. At the
same time the hidden channels are removed from the list of remote controllable channels, to
prevent them from being edited unnoticed.
Hidden channels in MIDI Remote x are removed from the list of remote controllable channels.
Within an 8-channel block of a Mackie compatible control they are skipped. The control there-
fore is no longer bound to consecutive orders. For example it will control channels 1, 2, and 6 to
11, when channels 3 to 5 are hidden.
The same can be done for OSC. With unnecessary channels made invisible for the OSC re-
mote the more important channels are available as one block on the remote.
The dialog can be
called directly from
TotalMix by a right
mouse click on any
channel. The cor-
responding channel
will then be pre-
selected in the
dialog.
The rows Inputs,
Playbacks and
Outputs are set up
individually by the
tabs at the top. In
Use shows which
channels are cur-
rently used in the
mixing process.
In the above example the AES input channel has been made invisible. When AES is not used
this is an easy way to remove it from the mixer completely. A more complex setup would be to
only show all channels of the drum section, the horn section or the violins.
After finishing those settings the whole state can be stored as Layout Preset.
A click on Store and the desired memory slot makes the current channel
layout recallable anytime. The button All makes all channels temporarily
visible again.
With a simple click on a button it will then be possible to easily switch views of
only the channels involved with the mixing of the drum section, the horn
section, the violins, or any other useful view. An optimized remote layout can
be activated here as well, with or without visible changes. Double-click the
default slot name to enter any other name.
Layout Presets are stored within the Workspace, so make sure to save the current state
before loading a different Workspace!
The button Sub activates another useful special view. When in Submix view, Sub will cause all
channels to disappear that are not part of the currently selected Submix/Hardware Output. Sub
temporarily shows the mix based on all channels from Inputs and Playback row, independent
from the current Layout Preset. That makes it very easy to see and to verify which channels are
mixed/routed to the current output. Sub makes checking and verifying of mixes, but also the mix
editing itself, a lot easier, and maintains perfect overview even with lots of channels.