User Manual

User's Guide Fireface UFX II © RME

6. Hardware, Driver and Firmware Installation

6.1 Hardware and Driver Installation

To simplify installation it is recommended to first install the drivers before the unit is connected

to the computer. But it will also work the other way round.

Insert the RME Driver CD into your CD-ROM drive. The driver installer is located in the directory

\MADIface_USB (NOT Fireface_USB)

Start rmeinstaller.exe and follow the instructions of the installer. After installation connect com-

puter and UFX+ using a USB 2 cable. Windows detects the new hardware as Fireface UFX II

and installs the drivers automatically.

After a reboot, the icons of TotalMix FX and Settings dialog appear

in the notification area.

Driver Updates do not require to remove the existing drivers. Simply install the new driver over

the existing one.

6.2 De-Installing the Drivers

A de-installation of the driver files is not necessary – and not supported by Windows anyway.

Thanks to full Plug & Play support, the driver files will not be loaded after the hardware has

been removed. If desired these files can then be deleted manually.

Unfortunately Windows Plug & Play methods do not cover the additional autorun entries of To-

talMix, the Settings dialog, and the registration of the ASIO driver. Those entries can be re-

moved from the registry through a software de-installation request. This request can be found

(like all de-installation entries) in Control Panel, Software. Click on the entry 'RME MADIface'.

6.3 Firmware Update

The Flash Update Tool updates the firmware of the Fireface UFX II to the latest version. It re-

quires an already installed driver.

Start the program fut_mfusb.exe. The Flash Update Tool displays the current revision of the

Fireface firmware, and whether it needs an update or not. If so, then simply press the 'Update'

button. A progress bar will indicate when the flash process is finished (Verify Ok).

After the update the unit needs to be reset. This is done by powering down the unit for a few

seconds. A reboot of the computer is not necessary.

When the update unexpectedly fails (status: failure), the unit's Safety BIOS will be used from

the next boot on, the unit stays fully functional. The flash process should then be tried again.