User Manual

User's Guide Fireface 802 © RME

DA, Line Out 1-8, rear

• Resolution: 24 bit

• Dynamic range (DR): 115 dB RMS unweighted, 118 dBA

• Frequency response @ 44.1 kHz, -0.5 dB: 5 Hz – 20.8 kHz

• Frequency response @ 96 kHz, -0.5 dB: 5 Hz – 45 kHz

• Frequency response @ 192 kHz, -1 dB: 5 Hz - 89 kHz

• THD: < -110 dB, < 0.00032 %

• THD+N: < -104 dB, < 0.00063 %

• Channel separation: > 110 dB

• Maximum output level: +19 dBu

• Output: 6.3 mm TRS jack, servo-balanced

• Output impedance: 75 Ohm

• Output level switchable Hi Gain, +4 dBu, -10 dBV

• Output level at 0 dBFS @ Hi Gain: +19 dBu

• Output level at 0 dBFS @ +4 dBu: +13 dBu

• Output level at 0 dBFS @ -10 dBV: +2 dBV

DA - Stereo Monitor Output Phones (9-12)

As DA, but:

• Output: 6.3 mm TRS stereo jack, unbalanced

• Maximum output level at 0 dBFS, High: +16.8 dBu

• Output impedance: 30 Ohm

34.2 MIDI

• 1 x MIDI I/O via 5-pin DIN jacks

• Galvanically isolated by optocoupled input

• Hi-speed mode: Jitter and response time typically below 1 ms

• Separate 128 byte FIFOs for input and output

34.3 Digital

• Clocks: Internal, ADAT In, AES In, word clock in

• Low Jitter Design: < 1 ns in PLL mode, all inputs

• Internal clock: 800 ps Jitter, Random Spread Spectrum

• Jitter suppression of external clocks: > 30 dB (2.4 kHz)

• Effective clock jitter influence on AD and DA conversion: near zero

• PLL ensures zero dropout, even at more than 100 ns jitter

• Digital Bitclock PLL for trouble-free varispeed ADAT operation

• Supported sample rates: 28 kHz up to 200 kHz