User's Manual
46 
User’s Guide ADI-2 DAC v2.2 © RME 
! 
24. General 
The ADI-2 DAC is a UAC 2.0 Class Compliant device. Mac OS X has full UAC support built-in, 
there is no driver installation required. Connect computer and ADI-2 DAC with a USB cable. 
Mac OS X detects the new hardware as ADI-2 DAC (serial number). 
For firmware updates please see chapter 7. 
24.1 Configuring the ADI-2 DAC 
Configuration of the ADI-2 DAC is mostly done directly at the unit. When set to Clock Source 
Internal, Mac OS X will set the current sample rate. 
Via  Launchpad – Other – 
Audio MIDI Setup the ADI-2 
DAC can be configured for the 
system wide usage. The 
Audio window includes a 
menu to select the sample 
rate. In Stereo mode up to 768 
kHz are supported, in Multi-
channel mode up to 192 kHz. 
The two modes can not be 
selected here, but have to be 
chosen at the unit while it is 
disconnected from the 
computer. 
Use  Configure Speakers to 
freely configure the stereo or 
multi-channel playback to any 
available channels. 
Applications that don't support card or channel selection will use the device chosen as Input 
and Output in the System Preferences – Sound panel. This setting is also available in the 
Audio MIDI Setup via the gear symbol at the bottom of the window. 
24.2 Clock Modes - Synchronization 
In the digital world, all devices must be either Master (clock source) or Slave (clock receiver). 
Whenever several devices are linked within a system, there must always be a single master 
clock. 
A digital system can only have one master! If the ADI-2 DAC’s clock mode is set to 'In-
ternal', all other devices must be set to ‘Slave’. 
To cope with some situations which may arise in studio practice, defining a sync reference is 
essential. RME’s exclusive SyncCheck technology enables an easy to use check and display 
of the current clock status. In the State Overview screen the column SYNC will show for all 
digital inputs whether there is a valid signal (Lock, No Lock) for the optical input, or if there is a 
valid and synchronous signal (Sync). See chapter 15.3. 










