User's Manual

User’s Guide ADI-2 DAC v2.2 © RME

14.1.4 Display

The subpage Display has the following entries:

Display Mode

Available settings are: Default, Dark. The dark scheme inverts the white background and black

numbers/text to black background and light-grey numbers/text in all menus.

Meter Color

Green, Cyan. Amber. Default: Green. Sets the meter screen colour in PCM and DSD mode.

Hor. Meter

The horizontal stereo level meter below the Analyzer can show the peak level before all DSP

processing (Pre, equals the current input level from USB playback and SPDIF In), after all

processing including volume control (Post), or both at the same time (Dual). The outer thin line

is the Pre level. In Dual mode the peak values to the right refer to Post level.

AutoDark Mode

OFF, ON. Default: OFF. Automatically turns off all LEDs and the display after 10 seconds of

user inactivity. A key press, turning an encoder, warning messages and the remote control will

temporarily activate LEDs and display again. Using the remote the time for entering dark mode

is 3 seconds.

Show Vol. Screen

ON, OFF. Default: ON. When turning the VOLUME knob the Volume screen is shown.

LCD Brightness

Adjustable from 20% to 100%. Default is 80%.

LCD Tint Control

Adjustable from -8 (yellow) to 8 (blue). Enables compensation of the display's colour deviation

as well as suiting the user's taste.

14.2 Load/Store all Settings

This option allows to save the whole state of the unit as Setup in up to 9 different memory slots.

The EQ Presets are not included, they are stored separately and are available for any setup.

The current state of the EQ is also stored. During load of a Setup the EQ is written to the mem-

ory slot Manual.

The page Setups, Load/Store all Settings, has the following entries:

Setup Select

Choices are Load 1-9, Factory (Reset All) and Store 1-9.

Name

Allows to edit the name of the Setup during the store

process. To edit an existing name load the respective Setup

and store it on the same memory slot with edited name. See

EQ - Name for details about the Edit operation.

Start

Press 1s. Pressing and holding encoder 2 for at least one second triggers the action selected

(Load or Store).

Returning to Factory State

Is described in chapter 7, page 11.