User's Manual

User’s Guide ADI-2 Pro FS - v 2.5

27. General

The ADI-2 Pro is a UAC 2.0 Class Compliant device. Mac OS X has full UAC support built-in,

there is no driver installation required. Connect computer and ADI-2 Pro with a USB cable. Mac

OS X detects the new hardware as ADI-2 Pro (serial number).

The number of available channels depends on the current Class Compliant mode: 2 channels

I/O when set to Stereo, 6 in / 8 out when set to Multi-channel. See chapter 14.1.3. Note: chang-

ing the CC-Mode requires to temporarily disconnect the interface from the computer.

For firmware updates please see chapter 7.

27.1 Configuring the ADI-2 Pro

Configuration of the ADI-2 Pro is mostly done directly at the unit. When set to Clock Source

Internal, Mac OS X will set the current sample rate.

Via Launchpad – Other –

Audio MIDI Setup the ADI-2

Pro can be configured for the

system wide usage. The

Audio window includes a

menu to select the sample

rate. In Stereo mode up to

768 kHz are supported, in

Multi-channel mode up to 192

kHz. The two modes can not

be selected here, but have to

be chosen at the unit while it

is disconnected from the

computer.

Use Configure Speakers to

freely configure the stereo or

multi-channel playback to any

available channels.

Applications that don't support card or channel selection will use the device chosen as Input

and Output in the System Preferences – Sound panel. This setting is also available in the

Audio MIDI Setup via the gear symbol at the bottom of the window.