User's Manual

User’s Guide ADI-2 Pro FS - v 2.5

14.1.4 Phones

Dual Phones

OFF, ON. Default: OFF. With Dual Phones ON the phones output PH 1/2 will be active. Default

state is Off, as PH 3/4 is the main phones output and should be used exclusively unless two

phones are to be connected.

If Dual Phones is on and two phones are plugged in, a push on VOLUME toggles between 1/2,

3/4 and linked volume control (with the marker over both). When VOLUME is turned the Dual

Volume screen is shown then.

Bal Phones Mode

OFF, ON, Auto. Default: OFF. In Balanced Phones mode output PH 3/4 carries the left channel,

output PH 1/2 the right channel. See chapter 18 for details. When Auto is selected, the bal-

anced phones mode is automatically activated as soon as both Phones outputs detect a con-

nector being plugged in. This feature temporarily deactivates DSD Direct mode if active.

Note

: When active, the rear analog outputs are muted automatically.

Phones <=> Line

OFF, 1/2, 3/4, 1/2+3/4. Default: OFF. Activates the ability to toggle mute between Phones Out

and rear Line Out. Pushing the VOLUME knob for half a second will then switch between loud-

speakers connected to the rear and phones plugged into the front. This function can also be

controlled by one of the four function keys via Remap Function Keys.

Mute v. TRS 1/2

ON, OFF. Default: ON, but grayed out. As soon as a plug is detected in PH 1/2 the rear outputs

1/2 are muted. Note: This function requires Dual Phones to be on to become accessible. With

Mute v. TRS 1/2 ON the channels Phones 1/2 and Mains Out 1/2 have separated settings. Al-

though both outputs alternately play back the same signal, all settings (Settings, EQ, BT) can

be different, and are separately stored in the background.

Mute v. TRS 3/4

ON, OFF. Default: ON. If set to ON a plug detected in PH 3/4 mutes the rear outputs 1/2.

14.1.5 Display

Display Mode

Available settings are: Default, Dark. The dark scheme

inverts the white background and black numbers/text to

black background and light-grey numbers/text.

Meter Color

Green, Cyan, Amber. Default: Green. Changes the color of

the level meters for PCM and DSD mode.

Hor. Meter

The horizontal stereo level meter below the Analyzer can show the peak level before all DSP

processing (Pre, equals the current input level from USB playback and SPDIF In), after all

processing including volume control (Post), or both at the same time (Dual). The outer thin line

is the Pre level. In Dual mode the peak values to the right refer to Post level.

AutoDark Mode

OFF, 10s. Automatically turns off all LEDs and the display (exception: Standby button) after 10

seconds of user inactivity. A key press and turning an encoder will temporarily activate LEDs

and display again. Info and warning messages are shown for 3 seconds.