User`s guide

User's Guide TEB

Connecting a TEB to the second ADAT In of a

HDSP 9652. Remove the jumper ST5, plug

DIGOUT of the TEB on both right and middle

pin of ST5.

6. Operation and Usage

Switch on the computer and boot the OS. The green LED on the TEB is lit when the power

supply is present. The red LED will be off as soon as the TEB receives a valid ADAT input sig-

nal via the DIG IN connector.

DIGI96 series

• Start the Settings dialog of the DIGI96/8 series, select the internal input (Input 'Internal'), set

Clock Mode to 'Master'.

• Connect the external device, which must be in clock mode slave, to the TDIF jack

• Connect the word clock output of the TEB with the word clock input of the TDIF device

• Verify that the clock select switch of the TEB is pressed

The Input Status must now show 'ADAT, 44.1 kHz, Internal' (or 48 kHz). In case 'No Lock' is

shown either the clock mode is not set up correctly, or the TEB is not connected correctly.

Hammerfall series and HDSP 9632/52

• Start the Settings dialog of the Hammerfall, select the internal input (AEB 'ADAT1 Internal'),

set Clock Mode to 'Master'.

• Connect the external device, which must be in clock mode slave, to the TDIF jack

• Connect the word clock output of the TEB with the word clock input of the TDIF device

• Verify that the clock select switch of the TEB is pressed

The Input Status in the field SyncCheck must now show 'ADAT1 In SYNC'. In case 'Lock' or 'No

Lock' is shown either the clock mode is not set up correctly, or the TEB is not connected cor-

rectly.

Clock Select Switch

The Clock Select switch of the TEB defines which reference clock is used by the TEB.

• Pushed: ADAT (PCI card)

• not pushed: TDIF (external device)

We recommend to set the switch according to the device being the current clock master. When

the external TDIF device is master: switch not pushed. With PCI card being master: switch

pushed.