User`s guide

User's Guide TEB

4. Technical Specifications

• TDIF Port: D-sub 25-pin

• Double Line mode: 4 channels at 88.2 kHz and 96 kHz (not with DIGI96 series)

• Supported sample rates: 44.1 kHz, 48 kHz, varispeed (33 - 57 kHz)

• Resolution: 24 bit

• Word clock out: BNC, low-impedance driver stage, 4 Vss into 75 Ohms, short-circuit-proof

• Sync source: ADAT (PCI card) or TDIF

• Power supply uses 3.5" floppy connector, 5 V DC, 100 mA

• Standard bracket, board dimensions: 75 x 95 mm

5. Hardware Installation

Important: Switch off the computer and remove the power cable from the power supply be-

fore fitting the TEB.

1. Disconnect the power cable and all other cables from the computer.

2. Remove the PC housing; further information on how to do this can be obtained from your

computer´s instruction manual.

3. Neutralize the static build up by touching the PC metal-chassis before unpacking the TEB

from the protective bag.

4. Connect TEB and PCI-card using the two supplied 2-wire cables. Plug one end into the con-

nector DIGOUT/SYNCOUT on the PCI card, the other end into DIGIN on the TEB.

5. Connect the TEB's DIG OUT and the PCI-card's CD-IN / SYNCIN / AEBIN using the sup-

plied 2-wire cable. Watch out for correct polarity: The shield wire is black, and must be con-

nected to the pin marked GND on the PCI-card (the right one).

6. Connect power supply: The TEB uses a floppy power connector (3,5"). In case no such con-

nector is available, use the supplied adapter cable to connect the TEB to any free 5 ¼"

power connector.

7. Insert the TEB into a free slot, press and fasten the screw. The TEB needs no slot on the

motherboard, but includes a stabilizing edge, which fits in both PCI and ISA slots.

8. Re-insert the PCI-card in a PCI slot and fasten the screw.

9. Re-place the PC housing and tighten the screws.

10. Re-connect the power cable and all other cables/connections.