User`s guide

User’s Guide HDSP System Multiface © RME

13.3 Synchronization

To achieve sample-accuracy between

the ADAT recorder and Hammerfall

DSP while running Cubase, connect

the ADAT sync output with the 9-pin D-

type sync input of the HDSP. The

‘Time Code’ field in the Settings

dialogue should now show the same

position as the ADAT recorder.

Double-clicking on the Sync button in

Cubase’s transport panel will open the

‘Synchronization’ dialog. Select ASIO

2.0 as the timecode base (under Sync

Source), confirm the dialog with ‘OK’,

then activate Sync mode by (single)

clicking on the Sync button.

If synchronization is not working i.e. Cubase does not respond when the ADAT is set to ‘Play’,

please try the following:

• Check the cables

• Switch Sync off and on again (in Cubase’s transport panel)

• Select ‘Reset Devices’ from the Options menu.

• Switch on the ADAT recorder(s) before starting Cubase

• Use the BRC as Master and send its word clock to all other devices

• Use the Clock Mode ADAT Sync