User`s guide

User's Guide HDSPe AIO © RME

13. Operation under ASIO 2.0

13.1 General

Start the ASIO software

and select ASIO Hammer-

fall DSP as the audio I/O

device. The 'ASIO system

control' button opens the

HDSPe's Settings dialog

(see chapter 11 / 19, Con-

figuration).

Hammerfall DSP supports

ASIO Direct Monitoring

(ADM). Please note that

currently Nuendo, Cubase

and Logic either do not

support ADM completely or

error-free. The most often

reported problem is the

wrong behaviour of pano-

rama in a stereo channel.

13.2 Channel Count under ASIO

At a sample rate of 88.2 or 96 kHz, the ADAT optical input and outputs operate in S/MUX mode,

so the number of available channels per port is reduced from 8 to 4.

At a sample rate of 176.4 and 192 kHz, the ADAT optical input and outputs operate in S/MUX4

mode, so the number of available channels per port is limited to 2.

Please note that when changing the sample rate range between Single, Double and Quad

Speed the number of channels presented from the ASIO driver will change too. This may re-

quire a reset of the I/O list in the audio software.

Mono channel Double Speed Quad Speed

AIO Analog 1 to 6 AIO Analog 1 to 6 AIO Analog 1 to 6

AIO AES L / R AIO AES L / R AIO AES L / R

AIO SPDIF L / R AIO SPDIF L / R AIO SPDIF L / R

AIO ADAT 1 to 2 AIO ADAT 1 to 2 AIO ADAT 1 to 2

AIO ADAT 3 to 4 AIO ADAT 3 to 4 AIO ADAT 3 to 4

AIO ADAT 5 to 8 AIO ADAT 5 to 8 AIO ADAT 5 to 8

Channels 3 to 6 shown above are a result of using the optional AI4S-192 and AO4S-192 Ex-

pansion Boards. The phones output (AIO Phones L / R) is displayed as output only.