User guide

76
User's Guide MADIface XT © RME
25.7 Preferences
The dialog Preferences can be opened via the Options menu or directly via F2.
Level Meters
¾ Full scale samples for OVR. Number
of consecutive samples to trigger an
over detection (1 to 10).
¾ Peak Hold Time. Hold time of the peak
value. Adjustable from 0.1 up to 9.9 s.
¾ RMS +3 dB. Shifts the RMS value by
+3 dB, so that full scale level is identical
for Peak and RMS at 0 dBFS.
Mixer Views
¾ FX Send follows highest Submix.
Locks the FX Send knob to the channel
fader. As TotalMix supports multiple
routings per channel, a definition is
needed which fader (only one is visible)
is the one that FX Send will follow. This
is always the one with the highest fader
position, means the highest gain.
¾ FX Send follows Main Out mix.
Gangs the FX Send knob only to the
channel fader of submix Main Out.
When a different submix is active FX
Send will not follow the fader.
¾ Center Balance/Pan when changing
Mono/Stereo. When switching a stereo
channel into two mono channels the
pan-pots are set fully left and right. This
option will set them to center instead.
¾ Disable double click fader action.
Prevents unintentional gain settings, for
example when using sensitive touch-
pads.
Dynamic Meters
¾ Compressor/Expander. Activates the
display of the Compressor/Expander’s
gain reduction as thin blue line in the
level meters of the corresponding
channel.
¾ Include Gain setting. The currently set fixed amplification value (by the Gain knob) is in-
cluded in the display. This can lead to positive values, with the display limited to +6 dB. In
case the option Compressor/Expander is deactivated this option is also not available, there-
fore grayed out.
¾ Auto Level. Activates the display of the variable amplification of the Auto Leveler. As Auto
Level can both amplify and attenuate the audio signal, depending on its configuration, the
display can show negative (typical gain reduction) as well as positive (above 0 dB, amplifi-
cation) values.
Snapshots
¾ Do not load Main volume/balance. The values stored in the Snapshot are not loaded for
the Main Out, so the current setting is not changed.