User`s manual

LOLA: Low Latency Audio Visual Streaming System
3. System Setup
3.1. Install required libraries and drivers
3.1.1 WinPcap (version 4.1.2 or later)
LOLA relies on the WinPcap windows packet capture library, which has to be installed on the PC.
The installer can be found at the following address:
http://www.winpcap.org
Note: Lola requires WinPcap version 4.1.2 or later.
3.1.2 BitFlow (SDK version 5.60)
Download and install the latest available firmware and drivers form the video board producer site:
http://www.bitflow.com/index.php/DownloadTable
In order to support 64 bits Windows version the minimal SDK version must be 5.60 (select
“Software BitFlow SDK 5.60"). In case you have installed previous SDK versions (or you are
upgrading an older LOLA version which runs with an SDK older than 5.60), you must first
remove the old SDK, and then install the new one. Also remember to reinstall, if needed, the
new LOLA CameraFiles (see ReadmeInstall.txt in the LOLA folder and also README.txt in
the CameraFiles subfolder).
You do not need a license code for the BitFlow SDK, thus just install it as “drivers only”,
when prompted for the serial number.
3.1.3 Visual C++ 2010 redistributable
Lola requires that the "Microsoft Visual C++ 2010 SP1 Redistributable Package (x86)" is installed
in your system. You can download the package from:
http://www.microsoft.com/en-us/download/default.aspx
and searching for "Microsoft Visual C++ 2010 SP1 Redistributable Package (x86)". In case you can
also apply the appropriate security patches, if any.
3.1.4 RME Audio Card
Download and install the latest available firmware and drivers from the audio board producer site.
http://www.rme-audio.de/en_downloads.php