User`s manual

LOLA: Low Latency Audio Visual Streaming System
Appendix D – Setting Cameras in External Trigger Mode
This section show how to correctly set in External Trigger Mode the supported cameras. If you are using a
camera not listed here, contact [e-mail] for assistance.
Sony HR50 setting for external trigger mode
If using the Sony HR50 B/W analog camera, the camera must be configured according to external
trig/shutter mode 2 (DIP switches 6,7 set to OFF, and DIP switch 8 set to ON, see Fig. 12).
Figure 12: Sony HR50 DIP switch setting for external trig/shutter mode 2
Hitachi KP-FD30 setting for external trigger mode
If using the Hitachi KP-FD30 color analog camera, the camera must be configured according to
external trig/shutter mode: the internal DIP switches (accessed by removing the back panel of the
camera) should be set as follows: SW6001 - Lower side (input sync), SW6002 - Upper side (Fig
13).
Figure 13: Hitachi KP-FD30 internal switch setting for external trig/shutter mode.
The camera rear switch should be set for progressive scan as follows: 1-On (VGA progressive
scan), 2-Off, 3-Off, 4-Off (Fig 14).