User`s manual

LOLA: Low Latency Audio Visual Streaming System
Cable for Toshiba IK-TF5
The cable for the Toshiba is very similar to the one for the Hitachi. Remove one of the VGA
connectors from the cable and connect to the 62 pin connector as shown in the following table (the
other VGA connector is already correctly connected to go on the camera), F3H982 Belkin cable:
(NC) = Not Connected
15 Pin Toshiba camera Comment Belkin cable 62 Pin DIN Comment
1 R Output No Y/C mode? Red Coaxial 23
2 G Output Green Coaxial 2
3 B Output Blue Coaxial 1
4 TXD Black (NC)
5 GND Brown 4
Shorted to Blue
Shield
6 GND Red Shield 11
7 GND Green Shield 6
8 Sync Wen? Blue Shield 4
Shorted to Blue
Shield
9 12V
Power from
BitFlow
(No wire) 5
No wire
available on
Belkin cable
10 GND Red (NC)
11 RXD Orange (NC)
12 Trig Yellow 25
13 HD In/Out Green 24
14 VD In/Out Grey 47
15 Index Wen? White 26
Shield GND Shield/Copper (NC) or 62
Connect to
improve
EMI/RFI
Rejection
Power Supply from the BitFlow card: the Belkin F3H982 cable does not have a wire to provide power
supply from the BitFlow board card (pin 5) to the camera (pin 9). If the cable you are using has a wire
available, just make the connection as above, and you will not need an external power supply for the camera.
Better grounding/shielding: even if not strictly ncessary, if you also connect the shield/ground as in the table
above, you may gain in image quality, expecially in “noisy” area with a lot of EMI/RFI.