User`s manual

LOLA: Low Latency Audio Visual Streaming System
Here is a detailed table for pinout connections, if you use the Belkin F3H982 and the Hitachi:
(NC) = Not Connected
15 Pin Hitachi camera Comment Belkin cable 62 Pin DIN Comment
1 R/C Output For Y/C mode Red Coaxial 23 2 tap mode?
2 G/Y Output For Y/C mode Green Coaxial 2 2 tap mode?
3 B/VBS Output Wen in Y/C mode? Blue Coaxial 1
4 WE Output Wen? Black 26
5 GND (TXD/RXD) Brown (NC)
6 Video GND Red Shield 11
7 Video GND Green Shield 6
8 Video GND Blue Shield 4
9 Unreg. +12V Input
Power from
BitFlow
(No wire) 5
No wire available
on Belkin cable
10 Trig Input Red 25
11 GND Orange (NC)
12 RXD Yellow (NC)
13
HD In/Out/Sync
Out
HD=Horizontal
Direction
Green 24
14 VD In/VD Out
VD=Vertical
Direction
Grey 47
15 TXD Wen? White (NC)
Shield GND Shield/Copper (NC) or 62
Connct to
improve
EMI/RFI
Rejection
Power Supply from the BitFlow card: the Belkin F3H982 cable does not have a wire to provide power
supply from the BitFlow board card (pin 5) to the camera (pin 9). If the cable you are using has a wire
available, just make the connection as above, and you will not need an external power supply for the camera.
Better grounding/shielding: even if not strictly ncessary, if you also connect the shield/ground as in the table
above, you may gain in image quality, expecially in “noisy” area with a lot of EMI/RFI.