User`s manual

LOLA: Low Latency Audio Visual Streaming System

Cable for Sony HR50

The VGA connector has 3 coaxial cables for video signal, but for b/w cameras you only need one;

just select, for example, the "G" (green) one. Use the twisted pairs for the other signals. Remove

both VGA connectors from the cable, and connect the pins as follows:

Hirosi 62pin signal comments

1 43 Ground

2 5 +12V

3 3 Ground VIDEO1 shield, coax

4 2 VIDEO1 VIDEO1 signal, coax

5 44 Ground

6 24 HD

7 47 VD

8 4 Ground

9 23 Ground

10 26 WEN_IN

11 25 TRIG_OUT

12 48 Ground

Cable for Hitachi KP-FD30

Remove one of the VGA connectors from the cable and connect to the 62 pin connector as shown in

Fig. 11, the other VGA connector is already correctly connected to go on the camera.

Figure 11: The cabling for the Hitachi KP-FD30 camera.

wen

trigger

wire shield

wire

shield

4 6

2623