User`s manual

LOLA: Low Latency Audio Visual Streaming System
Appendix C – Cameras Cabling Guide
Although you can buy appropriate cables for many of the analog cameras to be used with the BitFlow
grabber cards, this short guide can help you in building your own high quality cables.
In order to start, we suggest to use high quality VGA cables, which you can quite easily get anywhere. A
good reference model are for example the Belkin F3H982, which comes in different lengths. In some of the
tables you will find specific examples built using the Belkin F3H982 cables. Another very good alternate
cable, which also supplies power via the BitFlow card to the cameras, is the KSI (Kontact-Systeme Inter
Gmbh) model HYB 8 + 3 Koax (nr. 75 65 380) http://www.ksi.at/online-kataloge/kat7A/7A-565/7-565.pdf.
For b/w cameras you will often need a 12 pin Hirosi connector model HA10A-10P-12S, while color cameras
often use a standard 15pin VGA connector, thus you do not need to replace the one already on the cable.
For the BitFlow grabber 62 pin connectors the suggested parts are: Plug model AMP 748367-1, Shielding
HW model AMP 748471-1, Enclosure model AMP 748476-1
Please always check the camera documentation for the correct cabling. The following are the
schemas for LOLA supported cameras. In addition here is the BitFlow 62 pin cabling full
specification