User`s guide

User's Guide HDSP System Multiface © RME

36.2 Connector Pinouts

TRS jacks of analog input / output

The stereo ¼" TRS jacks of the analog inputs and outputs are wired according to international

standards:

Tip = + (hot)

Ring = – (cold)

Sleeve = GND

The servo balanced input and output circuitry allows to use monaural TS jacks (unbalanced)

with no loss in level. This is the same as when using a TRS-jack with ring connected to ground.

TRS Phones jack

The analog monitor output on

the front is accessible through

a stereo ¼" TRS jack. This

allows a direct connection of

headphones. In case the output

should operate as Line output,

an adapter TRS plug to RCA

phono plugs, or TRS plug to

TS plugs is required.

The pin assignment follows

international standards. The

left channel is connected to the

tip, the right channel to the ring

of the TRS jack/plug.