User`s guide

User's Guide HDSP System Digiface © RME

13.3 Synchronization

To achieve sample-accuracy between the ADAT

recorder and Hammerfall DSP while running

Cubase, connect the ADAT sync output with the

9-pin D-type sync input of the HDSP. The ‘Time

Code’ field in the Settings dialogue should now

show the same position as the ADAT recorder.

Double-clicking on the Sync button in Cubase’s

transport panel will open the ‘Synchronization’

dialog. Select ASIO 2.0 as the timecode base

(under Sync Source), confirm the dialog with

‘OK’, then activate Sync mode by (single) click-

ing on the Sync button.

If synchronization is not working i.e. Cubase does not respond when the ADAT is set to ‘Play’,

please try the following:

• Check the cables

• Switch Sync off and on again (in Cubase’s transport panel)

• Select ‘Reset Devices’ from the Options menu.

• Switch on the ADAT recorder(s) before starting Cubase

• Use the BRC as Master and send its word clock to all other devices

• Use the Clock Mode ADAT Sync