User`s guide
62
User's Guide Fireface 400 © RME
Hidden channels in Mixer/Matrix are still fully functional. An existing routing/mixing/FX process-
ing stays active. But as the channel is no longer visible it can not be edited anymore. At the
same time the hidden channels are removed from the list of remote controllable channels, to
prevent them from being edited unnoticed.
Hidden channels in MIDI Remote x are removed from the list of remote controllable channels.
Within an 8-channel block of a Mackie compatible control they are skipped. The control there-
fore is no longer bound to consecutive orders. For example it will control channels 1, 2, and 6
to 11, when channels 3 to 5 are hidden.
The same can be
done for OSC.
With unnecessary
channels made
invisible for the
OSC remote the
more important
channels are
available as one
block on the
remote.
The dialog can be
called directly
from TotalMix by a
right mouse click
on any channel.
The corres-
ponding channel
will then be
preselected in the
dialog.
Rows Inputs, Playbacks and Outputs are set up individually by the tabs at the top. Active indi-
cates currently available channels. At higher sample rates many ADAT channels are no longer
active. In Use shows which channels are currently used in the mixing process.
In the above example the SPDIF input channel has been made invisible. When SPDIF is not
used this is an easy way to remove it from the mixer completely. A more complex setup would
be to only show all channels of the drum section, the horn section or the violins.
After finishing those settings the whole state can be stored as Layout Preset.
A click on Store and the desired memory slot makes the current channel
layout recallable anytime. The button All makes all channels temporarily
visible again.
With a simple click on a button it will then be possible to easily switch views of
only the channels involved with the mixing of the drum section, the horn
section, the violins, or any other useful view. An optimized remote layout can
be activated here as well, with or without visible changes. Double-click the
default slot name to enter any other name.
Layout Presets are stored within the Workspace, so make sure to save the current state
before loading a different Workspace!