User`s guide

42
User's Guide Fireface 400 © RME
AutoSync Ref.
Displays the current clock source and sample rate of the clock source.
SyncCheck
SyncCheck indicates whether there
is a valid signal (Lock, No Lock) for
each input (Word clock, ADAT and
SPDIF), or if there is a valid and
synchronous signal (Sync). The
AutoSync Ref display shows the
input and frequency of the current
sync source.
System Clock
Shows the current clock state of the
Fireface 400. The unit is either Mas-
ter (using its own clock) or Slave
(AutoSync Ref).
Limit Bandwidth
Allows to reduce the amount of
bandwidth used on the FireWire
bus. See chapter 22.4.
All channels (default) activates all
18 input and output channels.
Analog + SPDIF activates all 10
analog channels plus SPDIF.
Analog 1-8 activates only the first
eight analog channels.
Read (Flash Memory)
A click on this button causes all settings to change to the ones stored in the flash memory of the
Fireface.
Store (in Flash Memory)
A click on this button transmits all current settings into the flash memory of the Fireface. Those
settings then become active directly after power-on, and also in stand-alone operation.