Users Manual

RM2TRACK-1-0 | ADVANCED SUPPLY CHAIN TRACKING TECHNOLOGY
© System Loco Ltd. 2020
General Device Operation
RM2TRACK-1-0 configuration shall be dependent upon the pallet’s end user. As such the device
configuration can be considered as a combination of:
 Baseline functionality
o Visibility of pallet movements (using LTE CAT-M and BLE local area network)
 Optional features
o Global visibility of pallet movements (2G)
o Integrity monitoring – Shock / Tip events
o Temperature logging and alerts
o Logging of short stops
o Locations of loading/unloading of BLE tagged goods (and/or pallets)
o Recovery – A-GPS
o Recovery – BLE (long-range)
Please Note:
 As ‘Optional features’ are activated there is additional demand on the battery, and therefore the
operational life of the device is expected to reduce. For each optional feature, the power
requirement shall be estimated to provide input to a Cost-Benefit-Analysis (CBA).
Baseline functionality
The RM2TRACK-1-0 ‘baseline functionality’ device configuration:
 Report on Journey start
o Based on B minutes of movement
 [B shall be configurable, default value = 20 minutes]
o Each Journey start report shall contain a listing of visible pallet IDs
 Report on Journey end
o Based on C minutes of no movement (after movement)
 [C shall be configurable, default value = 20 minutes]
o Each Journey start report shall contain a listing of visible pallet IDs, from the listing of
visible observed at Journey start.
 Status reporting
o If there has been no pallet journey for D days the RM2TRACK-1-0 shall send a report
to confirm that its location and operational status.
 [D shall be configurable, default value = 7 days]
o Status report will attempt LTE CAT-M connectivity, but then fallback to 2G upon LTE
CAT-M connectivity failure.