User manual

Caution: Do not attempt to run Setup and change the system
settings unless you understand what you are doing. You can
experience serious problems when using your notebook if you select
incorrect settings in Setup.
Full details on entering, changing the system settings and saving
changes and exiting are in the System Board User’s Manual (if
supplied).
Important: Before changing any system settings make a record of
all current settings first.
Changing the password
Password protection can be used to keep your data secure by
preventing unauthorised access to the system and Setup program.
By default, the Setup program is protected by a password.
The password can be a maximum of eight characters, i.e. you can
use any letter or number. The password may be case sensitive. Be
very careful to choose a password that you will not forget and
others will not be able to guess.
Caution: You should change the default password as soon as you
receive your notebook. If YOU do not change the default password,
someone else may change it for you and prevent you from
accessing the system. If you forget your password, you will need to
ring the RM helpline, or return your notebook to RM to be reset.
This reset is not covered by your warranty agreement. REMEMBER
THIS BEFORE YOU CHANGE YOUR PASSWORD - CHOOSE A
PASSWORD THAT YOU WILL REMEMBER.
The first time you change the password
The first time you select this option, you will need to enter the
default password. The default password is the password that has
been set up by Research Machines for use until you change the
password.
The default password is rm
When you have entered the default password correctly, the system
prompts you to enter the new password. You will have to enter the
new password twice for confirmation.