User guide

Tributary Slot Interface Selection

Trib utary Slo t Config uration S cree n

The iMux can use different modules that mount into slots in the back of the unit. These slots are called

Trib utary Slo ts, and must be configured before they can be used.

Note: The iMux has been pre-conﬁgured with appropriate settings for the Tributary Slots that were

used at the time it left the factory. These settings were initially saved in both Proﬁle I and

Proﬁle II. Changing these settings will alter the initial factory settings.

The Tributary Slot parameters and slot assignments are performed on the individual interface configuration

screens. To set up the Tributary Slots, select an interface to configure:

[1] E1InterfaceConfiguration

[2] V.35InterfaceConfiguration

[3] FXO/FXS Interface Configuration

[4] T1InterfaceConfiguration

[5] TributaryTSAConfiguration

Choose Next[F2] to configure the selected interface and corresponding Tributary Slot.

System Conﬁguration# RLH Industries, Inc. • 866-DO-FIBER • www.ﬁberopticlink.com! 55