User guide

Set the [F1] Auto Saving to ON and the auto saving interval in minutes to enable auto profile saving.

From the Profile Management screen select [2] Profile Operation and then Next[F2].

Profile Operation

This screen allows you to modify boot profiles. Although there are are four booting profiles, only Profile I and

Profile II may be user modified. Profile Factory Default and Profile Factory Default (IP

Address: 192.168.0.1) profiles may not be altered.

Note: The iMux has been pre-conﬁgured with appropriate settings for the modules that were

installed at the time it left the factory. These settings were initially saved in both Proﬁle I and

Proﬁle II. Changing these settings will alter the initial factory settings.

The Profile Modification will show Y if the profile has been changed anytime before loading the profile.

Select either Profile I or Profile II and press Load[F2] to open the profile for editing or review.

System Conﬁguration# RLH Industries, Inc. • 866-DO-FIBER • www.ﬁberopticlink.com! 49