Owner's Manual

82-5201-01 Email Generator • 9
2. If using a 9 - 12 VDC power source:
a. Disconnect the factory-installed red and black wires from the email/text generator’s input
terminals.
b. Route the DC wires through the strain relief bushing on the bottom of the housing.
c. Connect the power source’s “+” line to the “+” terminal on the DC terminal strip.
d. Connect the power source’s “-” line to the “-” terminal on the DC terminal strip.
Figure 4: DC Wiring
3. Wire the 2 terminals for each Contact Closure Input to the contacts they are intended to monitor.
4. Tighten the screw on the strain relief bushing to secure the wires.
5. Turn on the power source.
-
+
DC Power
Source