Owner's Manual

8 • 82-5201-01 Email Generator
Wiring
1. If using AC power:
a. Unscrew and remove the kep nuts from the AC terminal strip’s cover.
b. Route the AC wires through the strain relief bushing on the bottom of the housing.
c. Connect a line wire from the AC power source to the “H” terminal on the AC terminal strip.
d. Connect a neutral wire from the AC power source to the “N” terminal on the AC terminal
strip.
e. Connect a ground wire from the AC power source to the “G” terminal on the AC terminal
strip.
f. Reinstall the AC terminal strip’s cover using the kep nuts.
Figure 3: AC Wiring
GNL
AC Power
Source