User Manual

15 • Setting the Operational Parameters in Edit Mode
Turning on the SDM-E2 with an EAGLE 2
Do the following to turn on the SDM-E2 and establish a connection with an EAGLE 2:
1. Confirm that the AC Adapter is connected to the SDM-E2 and to an AC wall
socket.
2. Press and hold the SDM-E2’s POWER button. The LEDs will turn amber.
3. When the BUMP T and CAL S LEDs turn off, release the POWER button.
4. The COPY LED will be steadily on or off and the CHARGE LED will be blinking
green if the SDM-E2 is operating properly or solid red if there is a system
failure. The amount of free memory in the SDM-E2 will dictate the condition of
the COPY LED (see “Available Memory in the SDM-E2” on page 68).
5. Install an EAGLE 2 in the instrument cradle. Set the EAGLE 2 onto the top of
the SDM-E2 and slide the instrument forward until it falls into place as
illustrated.
WARNING: Inserting the EAGLE 2 improperly may damage the exhaust bellow at the
back of the SDM-E2.
Figure 10: Inserting the EAGLE 2
C a li bra ti on S ta tio n
COPY
EAGLE 2 OFF
CHARGE 1 SEC ON
3 SEC OFF
CAL
EDIT
ENTER
POWER
SDM-E2
BUMP
A
I
R
Y
E
S
R
A
N
G
E
S
H
I
F
T
P
O
W
E
R
E
N
T
E
R
R
E
S
E
T
D
I
S
P
L
A
Y
A
D
J
U
S
T
N
O