Owner manual

Connecting Instruments to the PC Controller Program 42
LED will begin to flash amber. If the batteries are fully charged, the CHARGE
LED will become solid green again after about 5 minutes. Typically a bump test
or calibration will be initiated before this happens. See “Charging an
Instrument in an SDM-E2” on page 103 for a complete description of charging
the EAGLE 2.
WARNING: Do not plug the charger cable into a battery pack that contains alkaline
batteries. Do not attempt to charge alkaline batteries.
7. When a connection has been established between the SDM Docking Station
PC Controller Program and all of the SDM-E2s, the main program window will
appear as shown below.
Figure 28: SDM-E2 Connection
8. Connect the gas out to EAGLE 2 line of each SDM-E2 to the inlet of each
EAGLE 2.