Configuration User Manual

Setting the Operational Parameters in Edit Mode • 30
4. Press and release the EDIT ENTER button.
• If a GX-2012 is inserted, the current setting for the H
2
S inlet will be
displayed. For instructions to change the H
2
S inlet setting, see “Setting the
Gas Inlet for H
2
S (GX-2012 Only)” on page 26.
Press and release the BUMP T button to display the current tested sensor
setting.
Continue to step 5.
• If a Gas Tracer is inserted, the current tested sensors setting will be
displayed.
GAS 1
H2S--IN
Std
GAS
Std
GAS