Configuration User Manual

25 • Setting the Operational Parameters in Edit Mode
5. Use the BUMP T and CAL S buttons to scroll through the different calibration
parameters.
6. To edit a parameter, press and release the EDIT ENTER button when that
parameter is displayed. An “E” will appear to the right of the parameter name.
7. Use the BUMP T and CAL S buttons to set the parameter to the desired
value, then press and release the EDIT ENTER button. The “E” to the right of
parameter name will disappear.
8. Repeat step 6 - step 7 to set any other parameters.
9. When you are done setting the parameters, use the BUMP T button to scroll
past the GAS--IN parameter screen. The screen will indicate that the
parameter changes have been saved.
The instrument will return to the home screen.
90
GAS--IN
45
E AIR--IN
45
90
DECISION