Instruction Manual

7 Maintenance 7-3. Gas calibration method
- 71 - RM-5000
<Setting of Gas Name of Measured Gas and Full Scale "2-7" - "SET 3">
<<Setting of Gas Name of Measured Gas and Full Scale>>
SET 3. GAS SELECT
Press SET key.
Press the ▲ or ▼ key to select
the target model "GP", "nc", or
"nc d", and then press the SET
key to confirm the value.
(GP-5001, NC-5001,
NC-5001W only)
Setting of Gas Name
Press the ▲ or ▼ key to select
either of the methods "ud"
(up-down input) and "no"
(number input), select a gas
name, and then press the SET
key to confirm the value.
During maintenance
During inhibit
Lamp on
Lamp off
Lamp blinking
Return to SE 3. GAS SEL