User Manual

Pioneer Operator’s Manual (PRELIMINARY) Combustible Gas Transmitter • 23

8. Reconnect the wiring from the Pioneer to the interconnect terminal strip as shown in

Table 4 and Figure 3, Wiring the Combustible Gas Transmitter to the Pioneer Gas

Monitor.

9. Reconnect the detector leads to the interconnect terminal strip as shown in Table 5 and

Figure 3, Wiring the Combustible Gas Transmitter to the Pioneer Gas Monitor.

10. Place the Pioneer’s power switch in the ON position.

CAUTION: Allow the detector to warm up for 15 minutes before you continue with the next step.

11. Calibrate the combustible gas transmitter as described in the Calibration section of

this insert.

Table 4: Reconnecting the Combustible Gas Ampliﬁer to the Pioneer Gas Monitor

Ampliﬁer

Interconnect Terminal Strip

Pioneer Analyzer Card

GND Gnd (Terminal 7)

4-20 4-20 (Terminal 5)

24V 24 V (Terminal 6)

Table 5: Reconnecting the Combustible Gas Detector to the Ampliﬁer

Detector Lead

Ampliﬁer

Interconnect Terminal Strip

Red SENSOR RED

White SENSOR WHT

Green SENSOR GRN

Black SENSOR BLK