User Manual

50 • Setting Commands
Calibration After Bump Test Failed
Calibrati on automatically begins after a failed bump test if set to
On (factory setting).
Updating an Instrument’s Detail Settings
Follow these steps to update an instrument’s deta il settings:
1. Launch the GX-2009 User Setup Pro gram as described in
“Launching the Program” on page 14.
2. Connect the GX-2009 to the User Setup Program as
described in “Connecting a GX-2009 to the U ser Setup
Program” on page 15.
3. With the Read Command Buttons now active, click
Instrume nt Infor mat i on to retrieve the instrument’s
parameter configuration. The program indicates that it is
downloading information from the instrument.
4. The instrument’s parameter confi guration is now loaded in
the User Setup Program.
Figure 39: Instrument Information Downloading