User Manual

4 • Introduction

Introduction

NOTE: The bump test funct ion in Calibration Mode is included

in instruments with firmware version 03955 or later

insta lled. See page 48 for a description of the bump t est

function. GX-2009 instruments shipped after May 2011

include the bump test function. Instrum ents that have a

serial number starting with 04516 or later shipped from

the factory with the bump test function available.

Instruments that have a serial number starting with

04515 did not include the bump test function when

shipped from the factory. The factory sett ing for the

bump test function is off.

CAUTION: Read and understand this manual before using the

GX-2009 User Setup Program. Also read and

understand the GX-2009 Operator’s Manual

included with the GX-2009 portable gas monitor.

Using an advanced detection system consisting of up to four gas

sensors, the GX-2009 Personal Gas Monitor detects the

prese nce of combust i ble gases, oxygen (O

), carbon monoxide

(CO), and hydrogen sulfide (H

S) simultaneously. The

GX-2009’s compact size and easy-to-use design make it ideally

suited for a wide range of applications as described in th e GX-

2009 Operator’s Manual. Please read the GX-2009 Operator’s

Manual first before using the GX-2009 User Setup Program.

The GX-2009 User Setup Program allows you to change various

instrument parameters not accessible in the GX-2009’s

Calibrati on Mode or User Setup Mode. It also allows you to save

parameter configuration files based on instruments’ parameter

settings t hat can be viewed or used to update another

instrument’s parameter settings

The purpose of this manual is to explain how to use the GX-

2009 User Setup Program. You will learn how to:

• install and launch the program