Instruction Manual

6 • Introduction
Introduction
Using an advanced detection system consisting of four gas
sensors, the Model GX-2001 Personal Four-Gas Monitor detects
the presence of combustible gases, oxygen (O
2
), carbon
monoxide (CO), and hydrogen sulfide (H
2
S) simultaneously. The
Model GX-2001’s compact size and easy-to-use design makes it
ideally suited for a wide range of applications, as described in
the Model GX-2001 Operator’s Manual, which you should read
first before using the GX-2001 Data Logging Software and GX-
2001 Calibration Station.
The GX-2001 Data Logging Software and Calibration Station
downloads stored data in the Model GX-2001 to a Windows-
based PC. After the data has been downloaded, you can view,
save, or print it using your computer and the GX-2001 Data
Logging Software. The GX-2001 Data Logging Software and
Calibration Station also calibrates the Model GX-2001 by setting
the zero and the span. The GX-2001 can also be recharged
using the calibration station.
The purpose of this manual is to explain how to use and set up
the GX-2001 Data Logging Software and Calibration Station.
You will learn how to:
• install and launch the software
• install the hardware
•down load data from the Model GX-2001
• view, print, and save data
• change data logging parameters
• change the appearance of data logging reports
• calibrate the Model GX-2001
• use the calibration station to recharge the Model GX-2001
• adjust the low flow alarm if necessary