Owner's manual

10,000 ppm Gas Tracer Operator’s Manual Overview • 50
Chapter 4: Maintenance Mode
Overview
This chapter describes the Gas Tracer in Maintenance Mode. In
Maintenance Mode, you can:
• update the date and time
• perform a fresh air adjust
• perform an auto calibration
• perform a single calibration
• perform a bump test
• calibrate and bump test the PPM combustible sensor
• turn the lunch break setting on or off
• update the alarm latching setting
• turn alarm silencing on or off
• update the interval trend time setting
• update warning, alarm, STEL, and TWA settings
• turn the clear data logger screen on or off
• turn the bump test function on or off
• turn the pump off screen on or off
• update bump test parameters
• update the confirmation beep setting
• update the data logger overwrite setting
• update the calibration interval setting
• turn the calibration reminder function on or off
• update the calibration expired action setting
• update the calibration check setting
• update the bump test interval setting
• turn the bump test reminder function on or off
• update the bump test expired action setting
• update the bump test check setting