Owner manual

EAGLE 2 Operator’s Manual Overview • 101
Appendix B: Setup Mode
Overview
This appendix describes the EAGLE 2 in Setup Mode. In Setup Mode, you
can:
• set the date and time
• set the date format
• set the battery type
• configure the channels
• configure the gas for a catalytic or PID channel
• set the detection units for the catalytic channel
• turn the catalytic sensor relative response feature on or off
• set the alarm points
• change the alarm latching setting
• turn the alarm silence feature on or off
• turn the user/station ID function on or off
• set the auto calibration values
• set the backlight delay time
• turn the automatic fresh air adjust feature on or off
• set the data logging interval time
• turn the data logger overwrite feature on or off
• turn the data log memory clear feature on or off
• adjust the display contrast
• turn the calibration reminder feature on or off
• set the calibration past due action
• set the calibration interval
• select the leak check/bar hole mode operation setting
• set the bar hole measurement time
• turn the zero follower on or off for each channel
• set the zero suppression level for each channel (except oxygen)