Instruction Manual

12 • 65-2428 H
2
S Detector
NOTE: If you do not allow the gas reading decrease below the alarm points, then
unwanted alarms may occur.
2. Verify that the controller display reading decreases and stabilizes at 0 ppm H
2
S.
3. Store the components of the calibration kit in a safe and convenient place.
Parts List
Table 2 lists replacement parts and accessories for the H
2
S detector.
Table 2: Parts List
Part Number Description
06-1248RK Sample tubing (order by the foot)
07-0033RK Detector housing cap gasket
07-0203RK Rubber retaining boot
14-2101RK Spacer between sensor and rubber boot
65-2428 H
2
S replacement detector assembly (includes sensor)
71-0344 65-2428 H
2
S Detector Operator’s Manual (this document)
81-0076RK Zero air calibration cylinder, 17 liter steel
81-0076RK-01 Zero air calibration cylinder, 34 liter steel
81-0076RK-03 Zero air calibration cylinder, 103 liter steel
81-0151RK-02 Calibration gas cylinder, 25 ppm H
2
S in nitrogen, 58 liter aluminum
81-0151RK-04 Calibration cylinder (25 ppm H
2
S in nitrogen; 34 liter aluminum)
81-1050RK Regulator with gauge and knob, 0.5 LPM, for 17 liter and 34 liter
steel calibration cylinders
81-1051RK Regulator with gauge and knob, 0.5 LPM, for 34AL/58/103 liter
calibration cylinders)
81-1117RK Calibration cup
ES-1537-H2S H
2
S replacement sensor