Manual

2 • 35-3010RKA-08 Sample-Draw Detector
Description
This section describes the components of the 35-3010RKA-08 sample-draw detector. The
sample-draw detector consists of the housing, flow system, and detection system.
Figure 1: Sample Draw Detector Component Location
Housing
The sample-draw detector’s fiberglass housing is weather- and corrosion-resistant. It is
suitable for installation where general purpose equipment is in use. The housing door is
hinged on the left side and is secured by two latches on the right side.
Four mounting feet are attached to the back of the housing (one at each corner). Use the
Hydrophobic
Filter (AcroPak)
Amp 1
Flow Block
for IR CH4
IR CH4
Sensor
Pump
H2S Dummy
Sensor
Charcoal Filter
LEL Transmitter
CO Dummy Sensor
Combustible
Sensor
Oxygen Sensor
Amp 2
Inlet Fitting For 1/4"
OD Rigid Tubing
Exhaust Fitting For 1/4"
OD Rigid Tubing
3/4 Conduit Hub, 2X
Flow
Block
Main Circuit Board
Oxygen
Transmitter
Reset Switch
Preamp
Circuit
Board